Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
18
SHUTDOWN PROCEDURE
Turning your OSBURN stove off is a matter of pressing
on the control panel. The blowers will continue to operate until internal firebox
temperatures have fallen to a preset level. The stove cannot restart before it has completely shut down.
SAFETY FEATURES
a. Your stove is equipped with a manual reset high temperature switch (also called heat sensor or heat switch). The switch has a reset button on
its backside. Like a circuit breaker, once tripped, the reset button will have to be pushed before you can restart the stove. The high
temperature switch protects the stove against overheating due to of an evacuation problem, a control board problem, a blower problem, or any
other problem causing the unit to overheat. The manufacturer recommends that you contact your dealer if this occurs as it may hide a major
problem. A service call may be required.
NOTE: If an overheating situation occurs, the high temperature switch (called the L-250 manual reset) will automatically shut down the auger
motor (fuel feed system) and a warning code
will appear.
b. If the combustion blower fails, an air pressure switch will automatically shut down the auger and a warning message
will appear. This
safety feature is to prevent the unit from igniting or burning fuel when the combustion/exhaust blower has failed, therefore preventing
combustion fumes from spilling into the room.
c. If the temperature in the auger rises beyond a certain acceptable level, two high temperature switches located under and above auger housing
will stop the fuel feed system and a warning
will appear.
CODE BEFORE RESETING TO RESET
H1, H2, H3
OR H4
Heat exchanger and/or exhaust system
is/are clogged. Refer to the owner’s manual
for maintenance procedures.
Press simultaneously for 2 seconds
and
icons.
*** After 3 attempts, reset is no longer possible, call SBI technical support.
DAMPER OPERATION
OP
E
N
C
L
OS
E
OP
E
N
C
L
OS
E
INSERT
STOVE
Figure 40
Damper operation
Stove & Insert
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Commentaires sur ces manuels

Pas de commentaire