Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur télécharger pdf (Page 7)

CLEARANCES

The HYBRID-35 has been tested and listed for installation in regular and

mobile homes.(refer figure 1 & 2)

FLOOR PROTECTION: minimum 6” in the front and 6” on each side. The

stove must be placed on a continuous (grouted joints) non-combustible

material such as ceramic tile, cement board, brick, 3/8” millboard or

equivalent, or other approved or listed material suited for floor protection.

NOTE: ceramic tile, or any tile, must be laid on a continuous non

combustible sheet to prevent the possibility of embers falling through to the

combustible floor if cracks or separation should occur in the finished

surface, this also applies to floor protection for Built-in raised hearths.

Check local codes for approved alternatives.

Clearances are measured from the sides, back and face (door opening) or

stove body (refer to fig. 3).

DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE

INSTALLATION OF THIS UNIT.

INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT

MANUFACTURER.

Figure 3

Floor protection

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Pas de commentaire

Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur Page 7