Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur télécharger pdf (Page 13)

INSERT INSTALLATION

The detailed instructions required to assemble the faceplate are supplied with the faceplate kit.

INSERT INTO EXISTING MASONRY FIREPLACE

NOTE: Follow pipe manufacturer’s instructions.

1. Have the masonry chimney inspected by a qualified

chimney sweep or installer to determine its structural

integrity.

2. You will need a pipe length equal to the chimney height from

the hearth. If outside combustion air is to be used, you will

need a pipe length equal to the chimney height plus 18

inches

3. Install a sealing cap at the top and bottom chimney

4. You can install a fresh air intake as per Figure 24:

- Option A through the floor

- Option B through the back wall

- Option C through chimney top

5. Attach the DuraVent adapter, a section of pipe and clean out

tee, making sure the clean out tee is centered in the

chimney flue area. Use RTV, metallic tape, and a minimum

of three self-taping screws at all joint connections to ensure

a tight seal.

*Minimum fireplace opening 23”W x 23”D x 20”H

Measure and build the chimney’s top sealing plate. Cut out holes for

chimney pipe and outside air pipe (if necessary). Install and seal with

flexible sealant to prevent water leakage. Install vent cap.

FACEPLATE

Figure 22

Exterior dimensions

Figure 23

Exhaust & air intake position

BOTTOM CHIMNEY CAP

TOP CHIMNEY CAP

VENT CAP

FLOOR

PROTECTION

FRESH AIR INTAKE

(OPTION A)

FRESH AIR INTAKE(OPTION C)

FRESH AIR INTAKE

(OPTION B)

Figure 24

Venting & air intake setup

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Pas de commentaire

Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur Page 13