Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur télécharger pdf (Page 29)

STOVE STOPS FEEDING PELLETS AND SHOWS

WARNING CODE “H”

Possible Causes: Possible Remedies:

1. One of the two L-250 automatic high temperature switches has been

tripped.

The L-250 automatic high temperature switches are located on the top and

bottom of the auger housing They send a signal to the control board if the

auger housing overheats. Wait until the stove cools down AND THEN

INSPECT YOUR UNIT. Improper installation, poor maintenance, or a

defective or missing component may be causing the stove to overheat.

Reset the stove and restart it. Call a technician if you get this code again.

*See procedure below to restart the stove.

CODE BEFORE RESETING TO RESET

H1, H2, H3

OR H4

Heat exchanger and/or exhaust system

is/are clogged. Refer to the owner’s manual

for maintenance procedures.

Press simultaneously for 2 seconds

and

icons .

*** After 3 attempts, reset is no longer possible. Call SBI technical support.

STOVE STOPS FEEDING PELLETS AND SHOWS

WARNING CODE “d”

Possible Causes: Possible Remedies:

1. The hopper lid has stayed open for more than 3 minutes

As a security measure, the auger will stop turning and feeding pellets as

soon as the hopper lid opens. It will resume normal operation as soon as

the hopper lid is closed. However, if the hopper lid stays open for more

than 3 minutes, the unit will stop and a code “d” will appear on the control

board. Close the hopper lid. Reset the unit and start it again.

THE STOVE IS RUNNING BUT DISPLAYS WARNING CODE

Possibles Causes: Possibles Solutions:

Warning generated by a power failure while the stove was

running.

The stove will restart on the initial setting once it cools off.

Note: For a short power failure (less than 5 seconds), the stove will continue to

function at the selected speed.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Osburn-stoves-by-sb-i HYBRID 35 Manuel d'utilisateur Page 29